CCTV Camera

Monitor and recorder connection:

Cameras are on, its time to make final connections. I will focused on standard CCTV monitor, standalone DVR recorder and distribution power supply, as this is the most popular and likely solution for most CCTV installations.

First we have to install BNC connectors on this side as well – its time for that coffee again. It is good idea to make room for monitor and recorder now and setup some type of desk, shelf or rack to place all the equipment on.

We need the monitor and recorder in place so we can determine proper power supply location. Power supply should be mounted within couple of feet from the DVR video inputs. After power supply is secured separate the power conductors from the Siamese cable, and run it to power supply.

Like we did with the cameras if 12VDC power is used, we need to watch the polarity, each terminal on the power supply is marked, so there should not be any doubt. Make sure the power supply is not plugged in to the power outlet yet.

Connect video cables to the DVR video in ports. We need one video cable to connect the DVR with the monitor, if you do not have one you may cut piece of Siamese cable separate the power conductors from it and install BNC connectors on both ends, you now have the cable. Connect the DVR monitor out port to monitor video in. We are almost ready to power up everything; there is only one more thing to take care before we do that.

We need to protect the equipment from power spikes by plugging it into power conditioner or better yet, buttery backup unit. If the installation location is experiencing frequent power outages, the backup unit is strongly recommended.

To extend the backup time only plug the DVR and camera power supply to the backup unit and the monitor to regular power strip, this way if we do loose power for some time the DVR and cameras are still functioning as normal while monitor is off. Turning off monitor will not affect DVR and cameras in any way; it is actually good habit to turn the monitor of if not used to extend its life.

Power on and final adjustment: Yes… we are now ready to power it up for the first time, if this is your first installation it may be nerve-racking experience. Start with turning the cameras power supply on, turn the monitor on as well followed by DVR system. The stand-alone DVR, after self-test will show cameras or setup menu on first power up depending on your model.

To setup the DVR refer to the manual for proper settings. Go over each camera view to determine if the view is actually what you want, hardly ever it will be without additional readjustments. To properly and easily adjust the positions, the test monitor will be very handy if not essential tool. Go to each camera location and connect the test monitor to adjust the position to your preferences, if satisfied secure camera bracket adjustment screws – we will not go back to this camera anymore.

Conclusion: Congratulations! You have just completed your most likely, very first installation of CCTV system. Visit our store fore more information on surveillance cameras, DVR recorders, tools and accessories. * article from : Robert Moskal

Tags: CCTV Camera – Do It Yourself Installation Guide #3

This entry was posted on Sunday, November 1st, 2009 at 2:07 pm and is filed under Uncategorized. You can follow any responses to this entry through the RSS 2.0 feed. You can leave a response, or trackback from your own site.